Intellijel Spock Manuel d'utilisateur télécharger pdf

Input X: Input 1 of the logic gates AND, OR and XOR. Feed a square/pulse 0-5V clock signal here.

intellijel

designs

Spock MANUAL

Input Y: Input 2 of the logic gates AND, OR and XOR. Feed a square/pulse 0-5V clock signal here.

AND Output: Buffered output of the AND logic gate. The state is indicated by the red led below it (when on the result is logic

HIGH or binary ‘1’).

OR Output: Bufferd output of the OR logic gate. The state is indicated by the yellow led above it.

XOR Output: Bufferd output of the XOR logic gate. The state is indicated by the green led below it.

NOT Input: This is a seperate input (not connected to the X and Y inputs) for the logic inverter. By default the

input is low (logic ‘0’) when nothing is patched in so the output is high (logic ‘1’).

NOT Output: Logice inverter output. When nothing is plugged in to the input you can use this output as a

positive voltage source since it would have a constant logic high.

NOTE: Only the top set of inputs and outputs are described since the bottom set are exactly identical

The Spock module comprises two sets of CMOS based dual input logic gates with te following functions: AND, OR, XOR and NOT. The top and bottom half of

the module are identical but can be combined together with patch cables to realise more complex logic functions.

This module is ideally used with clocks, triggers and other source of square pulses. Interesting results are also achieved by feeding audiorate signals into the gate

inputs and creating complex pulse based waveforms.

For more info on Logic Gates in general please visit : http://en.wikipedia.org/wiki/Logic_gate

INPUTS

Waveform: square or pulse waves ideally 0-5V (where 0V = logic low and 2V or greater is logic High)

max voltage: 10V

min voltage 0V

NOTE: unpredictable results with negtaive voltage

OUTPUTS

0-8V buffered

Max current draw: 35mA

Technical Specs

SPOCK top section

AND

XOR

SPOCK

AND

XOR

NOT

X Y AND OR XOR

1 1

0 0

1 1

NOT

Boolean logic table for the gates. A logic 1 represents an input signal of a positive square pulse (anything

greater than 2v but ideally 5-8V) . A logic ‘0’ is a signal of 0 volts / ground.

Spock MANUAL 1

Résumé du contenu

Page 1 - Spock MANUAL

Input X: Input 1 of the logic gates AND, OR and XOR. Feed a square/pulse 0-5V clock signal here. intellijeldesignsSpock MANUAL11Input Y: Input 2 of th

Commentaires sur ces manuels

Pas de commentaire

Intellijel Spock Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Audio Intellijel Spock. Intellijel Spock User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Audio Intellijel Spock